- Our crown moldings are the most simple and easiest crown moldings to install in America
- Our vaulted molding is self adjusting from 60 deg down to 135 deg up angles
- They install with simple painters caulk.
- Put a bead on the back surface where it meets the wall. (only 2 of the 4 surfaces are needed)
- Press molding to the wall. Then slide it up the wall until the top point makes contact with the ceiling.
- Next, align the molding up to the wall and press firmly into place.
- Then wipe off the excess caulk on the horizontal seams. Caulk you top seam.
- You have now installed your molding and finished your horizontal seams in one step.
INSTALLS ON FLAT 90 DEGREE CEILINGS
INSTALLS ON ANGLED, SLOPED / CEILINGS
JUST SLIDE IT UP THE WALL UNTIL THE TOP OF THE MOLDING COMES IN CONTACT
- Wood and MDF crown moldings absorb moisture and expand, then dry out and contract.
- In most cases people try to buy crown molding to fit the full length of their room.
- This usually results in a large amount of waste and difficulty in handling.
- Our foam crown moldings do not contract or expand so you can use any length available. (8 Ft)
- All you use on the vertical joints is sand-able spackle.
- Just apply the spackle into the joint, wait until it dries and sand with 220 grit sandpaper.
