As the old saying goes, if you want something done right, you must do it yourself. This philosophy is increasingly being adopted by homeowners, who are taking on more and more home improvement projects themselves.
Thanks to the internet, it is easier than ever for homeowners to get their hands dirty and tackle home improvement projects themselves. From painting the walls to fixing a leaky faucet, a wide range of projects can be tackled without professional help.
To enhance your home’s aesthetic appeal, you should install crown molding. It is a type of trim installed around the perimeter of a room where the ceiling meets the walls. Below are tips to ensure that you are getting the work done right:
Get the Right Measurements
Crown molding is a beautiful addition to any room, but it can be tricky to install. The key to successfully installing one is to get the correct measurements.
Before you start, measure the room’s width and the ceiling’s height. You also need to know the width of the molding itself. Once you have all these measurements, you can calculate the molding you need.
Next, you will need to mark the location of the molding on the wall. Use a level to ensure the molding is level as you install it. You may need to use shims to get the molding to sit level on the wall.
Finally, when you are ready to install the molding, use a miter saw to cut the molding at a 45-degree angle. It will give you a clean, professional-looking edge. No one likes buying extra materials for their mistakes, so it is vital to measure twice. It is a slight pain that can save you a lot of money and frustration in the long run.
Careful Installation
Crown molding is essential to any home’s décor, and it should be installed carefully to avoid damaging it. There are some pointers when installing one, such as:
- the type of nails to use
- the size of the gap between the wall and the molding
- the order in which the pieces should be installed.
When installing the architectural element, using the correct type of nails is essential. Nails that are too small can split the molding, while nails that are too large can cause the molding to crack. It is best to use finishing nails the same width as the molding.
The gap between the wall and the molding should be no more than 1/8 of an inch. If the gap is too large, the molding will not fit properly and will be more likely to crack. If the hole is too small, the molding will be challenging to install.
The order in which the pieces of crown molding are installed is also important. The base molding should be installed first, followed by the side moldings. The top molding should be installed last. It will ensure that the molding is adequately supported and less likely to crack.
Conclusion
Following the tips above will ensure that the installation project is successful. With careful planning and execution, you can achieve professional results that will add beauty and value to your home.
On top of the tips listed earlier, it is also critical to get high-quality merchandise from a reputable company. Creative Crown Foam Moldings is the leading supplier of crown molding in Florida. Check out our products now!
